AIR COOLED OIL COOLER REMOVAL


  1. REMOVE NO. 2 ENGINE UNDER COVER

  2. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A015ZFO

      Remove the 9 clips and cool air intake duct seal.

  4. SEPARATE HIGH PITCHED HORN ASSEMBLY


    1. A015Z96

      Disconnect the connector.

    2. Remove the bolt and high pitched horn assembly.

  5. REMOVE RADIATOR GRILLE PROTECTOR


    1. A01623G

      Remove the 2 radiator grille protectors.

  6. REMOVE FRONT BUMPER ASSEMBLY


    1. A0162OR

      Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the RH side and LH side.

    2. A0162S2

      remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. A0163H6E01

      Put protective tape around the front bumper assembly.

    4. Remove the 8 screws.

    5. A0161S5

      Using a clip remover, remove the 2 clips and screw.

    6. A01617S

      Disengage the 10 claws and disconnect the front bumper assembly as shown in the illustration.

    7. w/ LEXUS Parking Assist-Sensor system:


      1. Disconnect the ultrasonic sensor connector.

    8. Disconnect the headlight cleaner hose.

      Note

      Prepare a drain pan or a piece of cloth in case washer fluid leaks.

    9. Disconnect the 2 fog light connectors and remove the front bumper assembly.

  7. REMOVE OIL COOLER ASSEMBLY


    1. A016076E01

      Disconnect the 2 oil cooler hoses from the oil cooler assembly.

    2. Remove the 3 bolts and oil cooler assembly from the oil cooler bracket.