DESCRIPTION
The No. 2 ultrasonic sensor (rear right center sensor) is installed on the rear bumper.
The clearance warning ECU detects obstacles based on signals received from the rear right center sensor. If the rear right center sensor circuit has an open, short or other malfunction, it will not function normally.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2239 | Malfunction of No. 2 ultrasonic sensor (Rear right center sensor) |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
INSPECT NO. 2 ULTRASONIC SENSOR
| *1 | Component without harness connected (No. 2 Ultrasonic Sensor (Rear Right Center Sensor)) |
Remove the No. 2 ultrasonic sensor.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
| NG |
|
REPLACE NO. 2 ULTRASONIC SENSOR (REAR RIGHT CENTER SENSOR) Click here |
| OK |
|
CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - NO. 2 ULTRASONIC SENSOR)
Disconnect the clearance warning ECU connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Result | ||||||||
|---|---|---|---|---|---|---|---|---|
|
| B |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here |
| C |
|
REPLACE CLEARANCE WARNING ECU Click here |
| A |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR