LEXUS PARKING ASSIST-SENSOR SYSTEM, Diagnostic DTC:B2232

DESCRIPTION

The No. 1 ultrasonic sensor (front left sensor) is installed on the front bumper.

The clearance warning ECU detects obstacles based on signals received from the front left sensor. If the front left sensor circuit has an open, short or other malfunction, it will not function normally.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT NO. 1 ULTRASONIC SENSOR

   
   
   1. 

      Text in Illustration

      *1	Component without harness connected (No. 1 Ultrasonic Sensor (Front Left Sensor))

      Remove the No. 1 ultrasonic sensor.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 2 (S) - 1 (E) Always 20 to 40 kΩ

   
   

   NG

   REPLACE NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR) Click here

   OK

2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - NO. 1 ULTRASONIC SENSOR)

   
   

   1. Disconnect the clearance warning ECU connector.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition Q37-6 (S4) - D2-2 (S) Always Below 1 Ω Q37-19 (E4) - D2-1 (E) Always Below 1 Ω Q37-6 (S4) - Body ground Always 10 kΩ or higher Q37-19 (E4) - Body ground Always 10 kΩ or higher

      Result
      Result Proceed to NG A OK (When troubleshooting according to the Problem Symptoms Table) B OK (When troubleshooting according to the DTC) C

   
   

   B

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

   C

   REPLACE CLEARANCE WARNING ECU Click here

   A

   REPAIR OR REPLACE HARNESS OR CONNECTOR