LEXUS PARKING ASSIST-SENSOR SYSTEM CUSTOMIZE PARAMETERS


  1. CUSTOMIZE LEXUS PARKING ASSIST-SENSOR SYSTEM


    1. Customizing with the intelligent tester

      Note


      • When the customer requests a change in a function, first make sure that the function can be customized.

      • Be sure to make a note of the current settings before customizing.

      • When troubleshooting a function, first make sure that the function is set to the default setting.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the engine switch on (IG).

      3. Turn the LEXUS parking assist-sensor system on.

      4. Turn the tester on.

      5. Enter the following menus: Utility / Customize Setting.

      6. Select the setting by referring to the table below.

        Warning
        Tester Display Default Contents Setting
        Fr & Rr Buzzer Volume M2 Function to change volume of buzzer / L, M1, M2, M3 or H

        L: Low volume

        M1: Medium low volume

        M2: Medium volume

        M3: Medium high volume

        H: High volume
        Keep Sense Status Buzzer ON Function to make buzzer sound when distance between vehicle and obstacle does not change for more than 3 seconds ON / OFF
        Rear Buzzer Onset Range Wide Function to set rear buzzer activation range / Narrow or Wide

        Narrow: 600 mm(23.62 in.)

        Wide: 1500 mm (59.06 in.)
        Sensor
        Tester Display Default Contents Setting
        Sensor Condition N Range ON Make the sensors available when the shift lever is in N / ON or OFF

        ON: Available

        OFF: Not available
        Non P/R Range Sensor F Function to set available sensors when shift position is not in P or R / F, Rcrn2 or F

        F, Rcrn2: Corner sensors are available

        F: front sensors are available

    2. Customizing with multi-display assembly (w/ Multi-display)

      Note


      • When the customer requests a change in a function, first make sure that the function can be customized.

      • Be sure to make a note of the current settings before customizing.

      • When troubleshooting a function, first make sure that the function is set to the default setting.


      1. Turn the engine switch on (IG).

      2. Turn the LEXUS parking assist-sensor system on.

      3. Select the following menus: Setup / Vehicle / LEXUS Park Assist.

      4. Select the setting by referring to the table below.

        Display Default Content Setting
        Alert volume 3 Change the buzzer volume setting.

        1, 2, 3, 4 or 5


        • 1: Low volume

        • 2: Medium low volume

        • 3: Medium volume

        • 4: Medium high volume

        • 5: High volume
        Display On The display mode setting (when the LEXUS parking assist-sensor system is normal). On or Off
        Distance Wide Set the buzzer activation range for the rear center sensors.

        Narrow or Wide


        • Narrow: 600 mm (23.62 in.)

        • Wide: 1500 mm (59.06 in.)