AUTOMATIC TRANSMISSION SYSTEM, Diagnostic DTC:P0560

DTC Code DTC Name
P0560 System Voltage

DESCRIPTION

The battery supplies electricity to the TCM even when the engine switch is off. This power allows the TCM to store data such as DTC history, and freeze frame data. If the battery voltage falls below a minimum level, the stored TCM data is cleared and the TCM determines that there is a malfunction in the power supply circuit. When the engine is next started, the TCM will illuminate the MIL and set the DTC.

DTC Code DTC Detection Condition Trouble Area
P0560 TCM back-up power source circuit low voltage (1 trip detection logic)

  • Back-up power source circuit

  • TCM

Tech Tips

If DTC P0560 is set, the TCM does not store other DTCs.

WIRING DIAGRAM

A016210E01

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK TCM (POWER SOURCE, GROUND)


    1. A0161TWE17

      Disconnect the TCM connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A58-6 (BATT) - A58-2 (E1) Always 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A58-2 (E1) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, BODY GROUND)

    OK

  2. REPLACE TCM


    1. Replace the TCM Click here.


    NEXT

    PERFORM A/T CODE REGISTRATION Click here