OIL LEVEL SENSOR INSTALLATION


  1. INSTALL ENGINE OIL LEVEL SENSOR


    1. A01633P

      Install a new gasket to the engine oil level sensor.

    2. Insert the engine oil level sensor into the oil pan sub-assembly and rotate it 180° clockwise.

    3. A0162T1

      Install the engine oil level sensor with the 4 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    4. Connect the engine oil level sensor connector.

  2. INSTALL CRANK POSITION SENSOR BRACKET


    1. A0162ET

      Install the crank position sensor bracket with the bolt.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    2. Connect the harness clamp.

  3. CONNECT OIL COOLER TUBE SUB-ASSEMBLY


    1. Install the oil cooler tube bracket with the 3 bolts.

      A0161S9
      Torque:
      14 N*m  { 140 kgf*cm, 10 ft.*lbf }

    2. Install the 2 oil cooler tubes with the 2 clips.

  4. ADD AUTOMATIC TRANSMISSION FLUID

    Click here

  5. ADD ENGINE OIL


    1. Add fresh oil.

      Standard Engine Oil
      Oil Grade Oil Viscosity (SAE)
      API grade SM multigrade engine oil

      • 5W-30

      • 10W-30

      (5W-30 is best choice for fuel economy and good starting in cold weather.)
      Standard Capacity
      Item Specified Condition
      Drain and refill with oil filter change 9.3 liters (9.8 US qts, 8.2 Imp. qts)
      Drain and refill without oil filter change 8.2 liters (8.7 US qts, 7.2 Imp. qts)
      Dry fill 10.5 liters (11.1 US qts, 9.2 Imp. qts)

    2. Install the oil filler cap.

  6. INSPECT FOR OIL LEAK

  7. CHECK ENGINE OIL LEVEL


    1. Warm up and stop the engine, and then wait 5 minutes. The oil level should be between the dipstick low level mark and full level mark.

      If low, check for leaks and add oil up to the full level mark.

      Note

      Do not fill engine oil above the full level mark.

  8. INSTALL FRONT LOWER SUSPENSION MEMBER PROTECTOR


    1. A015ZJ4

      Install the front lower suspension member protector to the front suspension cross member with the 4 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  9. INSTALL NO. 2 ENGINE UNDER COVER

  10. INSTALL ENGINE UNDER COVER