ENGINE OIL COOLER REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A015ZFO

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE ENGINE UNDER COVER

  3. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the oil pan drain plug and drain the engine oil into a container.

    3. Install a new gasket and the oil pan drain plug.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }
  4. DRAIN ENGINE COOLANT


    1. Loosen the radiator drain cock plug.

      CAUTION:

      Do not loosen the radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

      Tech Tips

      Collect the coolant in a container and dispose of it according to local regulations.

    2. A0161WSE01

      Remove the radiator reservoir cap, and using a 6 mm socket hexagon wrench, remove the vent plug.

    3. Drain coolant.

    4. Loosen the 2 cylinder block drain cock plugs.

      A01603GE01
  5. REMOVE ENGINE OIL COOLER


    1. A0162GK

      Disconnect the 2 water by-pass hoses.

    2. A0163CKE01

      Remove the bolt, gasket, union bolt, oil cooler, and O-ring.