CANISTER INSPECTION


  1. INSPECT CHARCOAL CANISTER SUB-ASSEMBLY


    1. A01615DE01

      Visually check the charcoal canister sub-assembly for cracks or damage.

      If cracks or damage are found, replace the charcoal canister sub-assembly.

    2. Blow 4.4 kPa (45 gf/cm2, 0.63 psi) of compressed air into port A and check that air flows from port B and port C without resistance.

      If the result is not as specified, replace the charcoal canister sub-assembly.

    3. Apply a vacuum of 1.96 kPa (20 gf/cm2, 0.28 psi) to port A. Check that the vacuum does not decrease when ports B and C are closed, and check that the vacuum does not decrease when port B is released.

      If the result is not as specified, replace the charcoal canister sub-assembly.

  2. CLEAN FILTER IN CANISTER


    1. A0160Z9E01

      Clean the filter by blowing 4.4 kPa (45 gf/cm2, 0.63 psi) of compressed air into port A while holding port B closed.

      Tech Tips


      • Do not attempt to wash the charcoal canister sub-assembly.

      • No activated carbon should come out.