INJECTOR DRIVER INSTALLATION


  1. INSTALL INJECTOR DRIVER

    Note


    • Be careful not to drop or strike the injector drivers.

    • The injector drivers are grounded at the bolt and nut. To ensure that they are grounded, remove all oil and foreign matter from the installation areas of the injector drivers and engine before installing the injector drivers.


    1. A0160GS

      Install the 2 injector drivers to the intake air surge tank assembly with the 8 nuts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }
    2. A0162F0E01

      Connect the 8 injector driver connectors.


      1. Connect the 6 connectors with wire harness locks and the 2 connectors without wire harness locks to the 2 injector drivers.

        Note

        Connect the connectors securely.

        Tech Tips

        Move the lock lever in the direction indicated by the arrow to lock the connectors.

  2. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A0160IP

      Engage the 4 clips to install the V-bank cover sub-assembly.

      Note


      • Be sure to engage the clips securely.

      • Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.