DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE V-BANK COVER SUB-ASSEMBLY
Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the 2 clips on the rear of the cover and remove the V-bank cover sub-assembly.
Attempting to disengage both front and rear clips at the same time may cause the cover to break.
REMOVE INJECTOR DRIVER
Disconnect the 8 injector driver connectors.
Disconnect the 6 connectors with wire harness locks and the 2 connectors without wire harness locks from the 2 injector drivers.
To release each connector lock, push the claw downward ("Release" in the illustration) and move the lock lever ("Move" in the illustration).
Remove the 8 nuts and 2 injector drivers from the intake air surge tank assembly.
Be careful not to drop or strike the injector drivers.