INJECTOR DRIVER REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A0160IP

      Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the 2 clips on the rear of the cover and remove the V-bank cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  3. REMOVE INJECTOR DRIVER


    1. A015YIFE01

      Disconnect the 8 injector driver connectors.


      1. Disconnect the 6 connectors with wire harness locks and the 2 connectors without wire harness locks from the 2 injector drivers.

        Tech Tips

        To release each connector lock, push the claw downward ("Release" in the illustration) and move the lock lever ("Move" in the illustration).

    2. A0160GS

      Remove the 8 nuts and 2 injector drivers from the intake air surge tank assembly.

      Note

      Be careful not to drop or strike the injector drivers.