REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL ENGINE REAR OIL SEAL


    1. A015ZGVE01

      Using SST, tap in a new engine rear oil seal until its surface is flush with the oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )

      Note


      • Keep the lip free from foreign matter.

      • Do not tap on the oil seal at an angle.

      • Do not install the oil seal excessively.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01629JE01

      Using SST, hold the crankshaft.

      SST
      09213-38010
      09330-00021

    2. Clean the 10 bolt holes.

    3. A01619VE01

      Install the crankshaft angle sensor rotor.

      Tech Tips

      Align the pin hole of the crankshaft angle sensor rotor with the pin of the crankshaft.

    4. A015ZGJE01

      Install the drive plate and ring gear sub-assembly and drive plate spacer RR on to the crankshaft.

    5. A01614OE01

      Uniformly install and tighten 10 new bolts in the sequence shown in the illustration.

      Torque:
      30 N*m  { 301 kgf*cm, 22 ft.*lbf }

      Note


      • Do not reuse the drive plate and ring gear sub-assembly installation bolts.

      • Do not impact or damage the drive plate and ring gear sub-assembly installation bolts. Be sure to handle them carefully.

    6. A0161W6E01

      Mark the upside of each drive plate and ring gear sub-assembly installation bolt with paint.

    7. Retighten the drive plate and ring gear sub-assembly installation bolts 90° as shown in the illustration.

    8. Check that the painted marks are now at a 90° angle to the upside.

  3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here