ENGINE UNIT REPLACEMENT


  1. REPLACE TIMING CHAIN COVER STRAIGHT PIN


    1. A0160VLE01

      Remove the 4 straight pins.

    2. Using a plastic-faced hammer, tap in new straight pins to the timing chain cover sub-assembly.

      Standard protrusion
      5.5 to 6.5 mm (0.217 to 0.256 in.)

  2. REPLACE TIMING CHAIN COVER RING PIN


    1. A015Z1LE01

      Remove the 4 ring pins.

    2. Using a plastic-faced hammer, tap in new ring pins to the timing chain cover sub-assembly.

      Standard Protrusion
      Item Specified Condition
      Ring pin A 7.5 to 8.5 mm (0.295 to 0.335 in.)
      Ring pin B 3.6 to 4.6 mm (0.142 to 0.181 in.)

  3. REPLACE OIL PAN STUD BOLT


    1. A0161UNE01

      Using an E6 "TORX" socket wrench, install the 2 stud bolts as shown in the illustration.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. REPLACE ENGINE REAR OIL SEAL


    1. A0163DJE01

      Place the engine rear oil seal retainer on wooden blocks.

    2. Using a screwdriver and hammer, tap out the engine rear oil seal.

    3. A0162ALE01

      Using SST, tap in a new engine rear oil seal until its surface is flush with the engine rear oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note


      • Keep the lip free from foreign matter.

      • Do not tap on the engine rear oil seal at an angle.