AIR FUEL RATIO SENSOR REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disable the auto tilt away function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing this operation.

      Tech Tips

      Performing the above operation disables the auto tilt away function when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE ENGINE AND TRANSMISSION


    1. Remove the engine and transmission Click here.

  3. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    1. A0163EQE01

      Disconnect the air fuel ratio sensor connector.

    2. Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.

      SST
      09224-00010

  4. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    1. A015YTSE01

      Disconnect the air fuel ratio sensor connector.

    2. Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.

      SST
      09224-00010