CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A0160IP

      Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the 2 clips on the rear of the cover and remove the V-bank cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE CAMSHAFT POSITION SENSOR


    1. A016348

      Disconnect the camshaft position sensor connector.

    2. Remove the bolt and camshaft position sensor.

  3. REMOVE VVT SENSOR (for Bank 1)


    1. A0163AC

      Separate the 3 wire harness clamps.

    2. A0160GQ

      Disconnect the VVT sensor connectors.

    3. Remove the 2 bolts and 2 VVT sensors.

  4. REMOVE VVT SENSOR (for Bank 2)


    1. A0161RJ

      Separate the wire harness clamp.

    2. A01624E

      Disconnect the VVT sensor connectors.

    3. Remove the 2 bolts and 2 VVT sensors.