MASS AIR FLOW METER REMOVAL


  1. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A0160IP

      Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the 2 clips on the rear of the cover and remove the V-bank cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A015ZFO

      Remove the 9 clips and cool air intake duct seal.

  3. REMOVE ENGINE ROOM SIDE COVER RH (for LHD)


    1. A0161AL

      Remove the 3 clips and engine room side cover RH.

  4. REMOVE ENGINE ROOM SIDE COVER RH (for RHD)


    1. A015YK3

      Remove the 4 clips and engine room side cover RH.

  5. REMOVE MASS AIR FLOW METER


    1. A016334

      Disconnect the mass air flow meter connector.

    2. Remove the 2 screws and mass air flow meter.