CAMSHAFT OIL CONTROL VALVE INSTALLATION


  1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY LH


    1. A01612D

      Apply a light coat of engine oil to a new O-ring, and install it to the camshaft timing oil control valve assembly LH.

    2. A0160VB

      Install the camshaft timing oil control valve assembly LH with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly LH (the surface that contacts the cylinder head cover sub-assembly).

      • Be careful that the O-ring is not cracked or does not jump out of position when installing the camshaft timing oil control valve assembly LH.

    3. Connect the camshaft timing oil control valve connector.

  2. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY RH


    1. A01612D

      Apply a light coat of engine oil to a new O-ring, and install it to the camshaft timing oil control valve RH.

    2. A0162N0

      Install the camshaft timing oil control valve assembly RH with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly RH (the surface that contacts the cylinder head cover sub-assembly).

      • Be careful that the O-ring is not cracked or does not jump out of position when installing the camshaft timing oil control valve assembly RH.

    3. Connect the camshaft timing oil control valve connector.

  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. A015YT4

      Install the air cleaner cap sub-assembly with air cleaner hose and lock the 2 clamps.

      Tech Tips

      Tightening torque for the hose clamp located between the air cleaner cap sub-assembly and air cleaner hose assembly is as follows.

      Torque:
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }
    2. A015ZWF

      Connect the air cleaner hose to the throttle body with the hose clamp.

      Torque:
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }
    3. A015YRW

      Connect the 2 ventilation hoses with the 2 hose clamps.

    4. A01622I

      Connect the mass air flow meter connector and wire harness clamp.

  4. INSPECT FOR OIL LEAK

  5. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A0160IP

      Engage the 4 clips to install the V-bank cover sub-assembly.

      Note


      • Be sure to engage the clips securely.

      • Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.