CAMSHAFT OIL CONTROL VALVE REMOVAL


  1. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A0160IP

      Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the 2 clips on the rear of the cover and remove the V-bank cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A015YRW

      Loosen the 2 hose clamps and separate the 2 ventilation hoses.

    2. A01622I

      Disconnect the mass air flow meter connector and separate the wire harness clamp.

    3. A015ZWF

      Loosen the hose clamp and separate the air cleaner hose.

    4. A015YT4

      Unlock the 2 clamps and remove the air cleaner cap sub-assembly.

  3. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY RH


    1. A0162N0

      Disconnect the camshaft timing oil control valve connector.

    2. Remove the bolt and the camshaft timing oil control valve assembly RH.

    3. A01612D

      Remove the O-ring from the camshaft timing oil control valve assembly RH.

  4. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY LH


    1. A0160VB

      Disconnect the camshaft timing oil control valve connector.

    2. Remove the bolt and the camshaft timing oil control valve assembly LH.

    3. A01612D

      Remove the O-ring from the camshaft timing oil control valve assembly LH.