NAVIGATION SYSTEM (for DVD) Navigation ECU Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the display and navigation module display.

WIRING DIAGRAM

A01612ME08

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (DISPLAY AND NAVIGATION MODULE DISPLAY POWER SOURCE)


    1. Disconnect the J122 display and navigation module display connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      J122-10 (GND1) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      J122-1 (+B1) - J122-10 (GND1) Always 11 to 14 V
      J122-2 (ACC) - J122-10 (GND1) Engine switch on (ACC) 11 to 14 V
      J122-3 (IG) - J122-10 (GND1) Engine switch on (IG) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here