MULTI-MEDIA INTERFACE ECU (for RHD) INSTALLATION

INSTALL MULTI-MEDIA INTERFACE ECU
INSTALL NO. 1 MULTI-MEDIA INTERFACE BRACKET
1. Install the No. 1 multi-media interface bracket with the 2 bolts.
INSTALL NO. 2 MULTI-MEDIA INTERFACE BRACKET
1. Install the No. 2 multi-media interface bracket with the 2 bolts.
INSTALL MULTI-MEDIA INTERFACE ECU WITH BRACKET
1. Install the multi-media interface ECU with bracket with the 2 nuts and bolt.
2. Connect each connector.
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
1. Connect the connectors.
2. Engage the 2 claws.
3. Install the glove compartment door assembly with the 5 screws <D>.
INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
1. Check that the engine switch is off.
2. Check that the battery negative (-) cable is disconnected.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. Connect the front passenger side knee airbag connector to the front passenger side knee airbag assembly.
  
  Note
  
  When connecting the airbag connector, take care not to damage the airbag wire harness.
4. Install the front passenger side knee airbag assembly with the 3 bolts and claw.
  
  Torque:
  
  10 N*m { 102 kgf*cm, 7 ft.*lbf }
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
1. Engage the 4 clips to install the No. 2 instrument panel under cover sub-assembly.
INSTALL SIDE INSTRUMENT PANEL
1. Engage the 5 claws and 3 clips to install the side instrument panel LH.
INSTALL FRONT DOOR OPENING TRIM COVER
1. Engage the 4 claws and install the front door opening trim cover LH.
INSTALL FRONT DOOR SCUFF PLATE
1. Engage the 4 clips.
2. Engage the 7 claws and install the front door scuff plate LH.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSPECT SRS WARNING LIGHT

Click here