REAR DOOR SPEAKER REMOVAL


  1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    1. A015ZZC

      Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel plug.

  2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    1. A015ZOD

      Using a moulding remover, disengage the 2 claws and 2 clips.

    2. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.

  3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    1. A015ZS2

      Remove the 2 screws.

    2. Using a clip remover, disengage the 8 clips.

    3. A015YK2E02

      Pull out the rear door trim board in the direction indicated by the arrow.

    4. Remove the reference boss from the rear door panel.

    5. Raise the rear door trim board to disengage the 3 claws and remove the rear door trim board together with the rear door inner glass weatherstrip.

    6. A0162J7

      Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly.

    7. Disconnect each connector and remove the rear door trim board sub-assembly.

    8. Remove the 2 rear door trim board retainers (green) from the rear door trim board.

  4. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP


    1. A015ZZL

      Using a moulding remover, disengage the 3 clips as shown in the illustration and remove the rear door inner glass weatherstrip from the rear door trim board.

  5. REMOVE REAR SPEAKER ASSEMBLY


    1. A0161NO

      Disconnect the connector.

    2. Remove the 3 bolts and the rear speaker assembly.

      Note

      Do not touch the cone part of the speaker.

  6. REMOVE REAR NO. 2 SPEAKER ASSEMBLY


    1. A016082

      Disengage the speaker connector clamp.

    2. Disengage the 3 claws and remove the rear No. 2 speaker assembly.

      Note

      Do not touch the cone part of the speaker.

  7. REMOVE REAR NO. 3 SPEAKER ASSEMBLY (w/o Front Center Speaker)


    1. A0160N2

      Disconnect the connector.

    2. Remove the 2 bolts and the rear No. 3 speaker assembly.

      Note

      Do not touch the cone part of the speaker.