AUDIO AND VISUAL SYSTEM (w/o Navigation System) Integration Control and Panel Assembly Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the integration control and panel assembly.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY

   
   
   1. 

      Text in Illustration

      *1	Front view of wire harness connector (to Integration Control and Panel Assembly)

      Disconnect the integration control and panel assembly connector.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition J54-8 (E) - Body ground Always Below 1 Ω

   3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition J54-14 (B) - J54-8 (E) Always 11 to 14 V J54-5 (ACC) - J54-8 (E) Engine switch on (ACC) 11 to 14 V J54-4 (IG+) - J54-8 (E) Engine switch on (IG) 11 to 14 V

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here