NAVIGATION ECU INSTALLATION


  1. INSTALL NAVIGATION ECU


    1. A0161TG

      Install the navigation ECU with the 4 screws.

    2. A0162FK

      Connect the connectors.

  2. INSTALL MULTI-DISPLAY ASSEMBLY


    1. A0163B0

      Install the multi-display assembly as shown in the illustration.

  3. INSTALL NO. 2 RADIO BRACKET


    1. A015Z6H

      Install the No. 2 radio bracket with the 7 bolts.

  4. INSTALL NO. 1 RADIO BRACKET


    1. A0160LX

      Install the No. 1 radio bracket with the 7 bolts.

    2. A015YV5

      Engage the connector clamp.

  5. INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY


    1. Connect each connector.

    2. A0162FS

      Install the the multi-display with radio receiver assembly with the 4 bolts.

  6. INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL


    1. A0160YT

      Engage the 4 claws and install the center lower instrument cluster finish panel.

  7. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A0160X4

      Connect the connectors.

    2. Engage the 11 claws and install the No. 3 instrument panel register assembly.

  8. INSTALL FRONT ASH RECEPTACLE ASSEMBLY


    1. A0162Y8E02

      Connect the connectors.

    2. Insert the protruding parts of the front ash receptacle assembly into the 2 guide holes as shown in the illustration.

    3. A0160IR

      Install the front ash receptacle assembly with the 2 screws <E>.

  9. INSTALL CONSOLE PANEL SUB-ASSEMBLY


    1. A015ZS3

      Connect the connectors.

    2. Engage the 8 clips and install the console panel sub-assembly.

  10. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH


    1. A0161VR

      Engage the claw and 2 clips, and then install the upper No. 2 console panel garnish.

  11. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH


    1. A0161PI

      Engage the claw and 2 clips, and then install the upper No. 1 console panel garnish.

  12. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A0160BL

      Turn the shift lever knob clockwise and install the shift lever knob sub-assembly.

  13. INSERT MAP DISC


    1. A0160QD

      Remove the clock assembly.

    2. Turn the engine switch on (ACC).

    3. Insert the map disc.

    4. A01624XE01

      Check that the wire harness is in the position shown in the illustration.

    5. A0162SY

      Engage the 2 clamps and install the clock assembly.

  14. ADJUST CLOCK