SLIDING ROOF HOUSING REASSEMBLY


  1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    1. A017E8D

      Insert the sliding roof drive cable.

    2. Align the sliding roof drive cable with the guide on the sliding roof housing and slide the cable in the direction indicated by the arrow in the illustration.

    3. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.

      A017F16E01

      Note

      Make sure that the spring indicated by the arrow in the illustration is securely installed.

    4. A017CP4

      Engage the 2 claws and install the sliding roof drip channel.

    5. A017F19

      Install the sliding roof side stopper with the screws.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

      Tech Tips

      Use the same procedure for the RH side and the LH side.

  2. ADJUST FULLY CLOSED POSITION


    1. A017G94E02

      Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction indicated by the arrows in the illustration and alignment marks.

      Tech Tips

      Tape the screwdriver tip before use.

  3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    1. A017CPE

      Insert the sunshade trim into the sliding roof housing sub-assembly.

    2. A017FEJ

      Align the sliding roof piece sub-assembly LH with the guide on the sliding roof housing to temporarily install it.

    3. A017E7H

      Install the sliding roof piece sub-assembly LH with the screw.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

      Tech Tips

      Use the same procedure for the RH side and the LH side.

  4. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A017FOS

      Install the sliding roof drive gear sub-assembly with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }