Click here

BACK DOOR SUPPORT INSTALLATION

Click here
Click here
  1. Click here

    INSTALL BACK DOOR STAY ASSEMBLY

    Note:

    • Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinders while servicing.

    • Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

    • Do not apply any horizontal load to the door stay in the in order to prevent the rod from being deformed.


    1. Clean the threaded surface on the vehicle body with a non-residue solvent.

    2. Apply adhesive to the threads of the 4 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    3. A017FTW

      Install the back door stay assembly with the 4 bolts.

      8.0 N*m 82 kgf*cm 71 in.*lbf
      Note:

      Install the back door stay assembly while supporting the back door by hand.

    4. Check that the back door stay assembly is engaged in the ball joint and that the back door stay assembly cannot be pulled out.