Click here

HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL

Click here
Click here
  1. Click here

    REMOVE ENGINE UNDER COVER ASSEMBLY


    1. A017FPR

      Remove the 2 bolts and engine under cover assembly RR.

    2. A017FXN

      Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.

  2. Click here

    REMOVE NO. 1 ENGINE UNDER COVER


    1. A017B8T

      Remove the 6 bolts, 2 clips and No. 1 engine under cover.

  3. Click here

    REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH


    1. A017F6U

      Remove the clip.

    2. Using a 4 mm hexagon wrench, remove the screw.

    3. A017C5R

      Peel off the front fender side protector and disengage the 3 clips, and then remove the front fender moulding sub-assembly.

    4. Remove the pad from the front fender moulding sub-assembly.

    5. Remove the 2 No. 4 clips from the front fender moulding sub-assembly.

    6. A017BKRE01

      Remove the front fender side protector from the front fender moulding sub-assembly.

  4. Click here

    REMOVE FRONT FENDER LINER LH


    1. A017ERME01

      Remove the screw.

    2. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    3. A017F68

      Using a 4 mm hexagon wrench, remove the 2 screws.

    4. Remove the 2 grommets.

      Tip:

      The grommets need to be replaced with new ones because they will break when they are removed.

    5. A017CTK

      Remove the 5 clips, 8 screws and front fender liner LH.

  5. Click here

    REMOVE COOL AIR INTAKE DUCT SEAL


    1. A017EZQ

      Remove the 11 clips and cool air intake duct seal.

  6. Click here

    REMOVE RADIATOR GRILLE


    1. A017GBWE01

      Put protective tape around the radiator grille.

    2. A017DWF

      Remove the 2 bolts and 4 clips.

    3. A017G18

      Disengage the 6 claws and 4 guides, and remove the radiator grille.

  7. Click here

    REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)


    1. A017D3E

      Remove the hood lock nut cap.

    2. A017CPZ

      Remove the 3 bolts.

    3. A017DBV

      Disconnect the hood lock control cable and remove the hood lock assembly.

  8. Click here

    REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)


    1. A017EVU

      Disconnect the connector.

    2. A017FVJ

      Remove the hood lock nut cap.

    3. A017CI6

      Remove the 3 bolts.

    4. A017BQ6

      Disconnect the hood lock control cable and remove the hood lock assembly.

  9. Click here

    REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


    1. A017CKA

      Disconnect the hood lock control cable from the hood lock control lever.

    2. A017DRNE01

      Using a screwdriver, disconnect the clamps shown in the illustration.

      Area Part Name Area Part Name
      A Hood lock control cable E Fender liner
      B Clamp F Hood stopper rubber
      C Hood cable grommet G Front washer hose
      D Wire harness H Rear washer hose
      Tip:

      Tape the screwdriver tip before use.

    3. Pull the cable from the engine compartment and remove it.