Click here

POWER WINDOW RELAY ON-VEHICLE INSPECTION

Click here
Click here
  1. Click here

    INSPECT POWER WINDOW RELAY (Marking: PWR)


    1. Remove the power window relay from the instrument panel junction block.

    2. Measure the resistance of the relay.

      Table 1. Standard resistance
      Tester Connection Condition Specified Condition
      3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Apply battery voltage between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the relay.