POWER WINDOW REGULATOR MOTOR INSPECTION


  1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side)


    1. Apply battery voltage to the motor connector according to the table below.

      Note


      • Do not apply voltage to any terminals except terminals 1 and 2, to avoid damaging the pulse sensor inside the motor.


      • Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door.

      A017F15E01

      Note

      Do not apply battery voltage to any terminals except terminals 1, 2, 4, 7 and 10.

      OK
      Switch Condition Measurement Condition Specified Condition
      Manual Operation

      Battery positive (+) → Terminal 2 (B)

      Battery negative (-) → Terminal 1 (E), 7 (DWN1)

      		 Motor gear rotates counterclockwise

      Battery positive (+) → Terminal 2 (B)

      Battery negative (-) → Terminal 1 (E), 10 (UP1)

      		 Motor gear rotates clockwise
      Auto Operation

      Battery positive (+) → Terminal 2 (B)

      Battery negative (-) → Terminal 1 (E), 4 (AUTO), 7 (DWN1)

      		 Motor gear rotates counterclockwise

      Battery positive (+) → Terminal 2 (B)

      Battery negative (-) → Terminal 1 (E), 4 (AUTO), 10 (UP1)

      		 Motor gear rotates clockwise

      If the result is not as specified, replace the regulator motor assembly.

  2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Side)


    1. Apply battery voltage to connector terminals 1 and 2.

      Note

      Do not apply battery voltage to any terminals except terminals 1 and 2.

      A017C12E02

    2. Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 1

      Battery negative (-) → 2

      		 Motor gear rotates clockwise

      Battery positive (+) → 2

      Battery negative (-) → 1

      		 Motor gear rotates counterclockwise

      If the result is not as specified, replace the regulator motor assembly.

  3. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side)


    1. A017EIGE05

      Apply battery voltage to connector terminals 1 and 2.

      Note

      Do not apply battery voltage to any terminals except terminals 1 and 2.

    2. Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 1

      Battery negative (-) → 2

      		 Motor gear rotates clockwise

      Battery positive (+) → 2

      Battery negative (-) → 1

      		 Motor gear rotates counterclockwise

      If the result is not as specified, replace the regulator motor assembly.

  4. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH Side)


    1. A017FM2E04

      Apply battery voltage to connector terminals 1 and 2.

      Note

      Do not apply battery voltage to any terminals except terminals 1 and 2.

    2. Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 1

      Battery negative (-) → 2

      		 Motor gear rotates clockwise

      Battery positive (+) → 2

      Battery negative (-) → 1

      		 Motor gear rotates counterclockwise

      If the result is not as specified, replace the regulator motor assembly.