GLASS HATCH OPENER SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the intelligent tester to read the DATA LIST allows values or status of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

    CAUTION:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menu.


      1. Select: Body / Main Body / Data List.

        Main Body:
        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        Back Door Courtesy SW Back door courtesy switch signal / ON or OFF

        ON: Back door is open

        OFF: Back door is closed

        		 -
        Glass Hatch Courtesy SW Glass hatch courtesy switch signal / ON or OFF

        ON: Glass hatch is open

        OFF: Glass hatch is closed

        		 -
        Glass Hatch Opener Switch Glass hatch opener switch signal / ON or OFF

        ON: Glass hatch opener switch operates

        OFF: Glass hatch opener switch does not operate

        		 -

  2. ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform ACTIVE TEST allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. DATA LIST information can be displayed while performing ACTIVE TEST.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menu.


      1. Select: Body / Main Body / Active Test.

        Main Body:
        Tester Display Test Part Control Range Diagnostic Note
        Glass Hatch Open Operate Glass Hatch ON or OFF -