POWER WINDOW CONTROL SYSTEM DIAGNOSIS SYSTEM


  1. DESCRIPTION


    1. The power window control system data can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.

  2. CHECK DLC3


    1. Check the DLC3 Click here.

  3. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage.

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    2. CHECK DIAGNOSIS

      A017EHC

      Tech Tips

      If there is a malfunction in the pulse sensor, manually operating the power window switch will cause the power window switch light to blink.


      1. Turn the ignition switch on (IG).

      2. Manually operate the power window master switch or power window switch on each door.

      3. Check the blinking pattern of the AUTO light as shown in the illustration.

        A017D53E04

        1. If pattern (A) is displayed, check the wire harness or power window ECU.

        2. If pattern (B) is displayed, check the power window regulator motor or power window ECU.

        3. If the normal pattern is displayed, replace the power window regulator master switch.