CLOCK (w/o Multi-information Display) REMOVAL


  1. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A017DDAE01

      Apply protective tape to the areas shown in the illustration.

    2. Using a moulding remover, disengage the 2 claws and 5 clips, and then remove the center instrument panel register assembly as shown in the illustration.

  2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. A017BKEE01

      Apply protective tape to the areas shown in the illustration.

    2. Using a moulding remover, disengage the 10 claws and 8 clips starting from the upper part of the center instrument cluster finish panel assembly.

      Note

      Do not pull on the small storage compartment lid. Doing so may cause damage.

    3. Disconnect each connector and remove the center instrument cluster finish panel assembly.

  3. REMOVE HEATER CONTROL AND ACCESSORY ASSEMBLY


    1. A017G04

      Disengage the 4 clips and remove the heater control and accessory assembly.

    2. Disconnect the connector.

  4. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET


    1. A017FXP

      Remove the 4 bolts.

    2. A017EFV

      Pull the radio receiver assembly with bracket toward the rear of the vehicle and disengage the 4 clips.

    3. Disconnect each connector and remove the radio receiver assembly with bracket.

  5. REMOVE NO. 1 RADIO BRACKET


    1. A017GBL

      Disengage the claw and remove the connector.

    2. A017E7U

      Remove the 4 screws and No. 1 radio bracket.

  6. REMOVE NO. 2 RADIO BRACKET


    1. A017BHI

      Remove the 4 screws and No. 1 radio bracket.

  7. REMOVE CLOCK ASSEMBLY