Click here

CLOCK SYSTEM Power Source Circuit

Click here
Click here
DTC Code DTC Name
  Power Source Circuit
Click here

DESCRIPTION

This circuit is the power source for the clock assembly. This circuit provides two types of power sources; one is a constant power source mainly used as a backup power source, and the other is a power source mainly used for signal transmission.

Tip:

If the clock assembly displays "1:00" when the ignition switch off, then on (IG) again, the B (*1) or +B (*2) terminal has a malfunction.

The maximum clock assembly margin of error is -4 to 4 seconds per day when the temperature is between -20°C (-4°F) and 60°C (140°F).


  • *1: w/o Multi-information Display

  • *2: w/ Multi-information Display

Click here

WIRING DIAGRAM


Click here
  1. A017CPRE10

    w/o Multi-information Display

  2. A017CPRE11

    w/ Multi-information Display

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR


    1. A017FUOE03

      Disconnect the E20 (*1) or E9 (*2) connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      E20-1 (B) (*1) - Body ground Always 11 to 14 V
      E9-6 (+B) (*2) - Body ground Always 11 to 14 V
      E20-4 (ACC) (*1) - Body ground Ignition switch on (ACC) 11 to 14 V
      E9-1 (IG) (*2) - Body ground Ignition switch on (IG) 11 to 14 V

      *1: w/o Multi-information Display

      *2: w/ Multi-information Display

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      E20-2 (E) (*1) - Body ground Always Below 1 Ω
      E9-5 (GND) (*2) - Body ground Always Below 1 Ω

      *1: w/o Multi-information Display

      *2: w/ Multi-information Display

      Result
      Result Proceed to
      OK (w/o Multi-information Display) A
      OK (w/ Multi-information Display) B
      NG C

  2. Click here

    REPLACE CLOCK ASSEMBLY (w/ Multi-information Display)Click here

  3. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  4. Click here

    REPLACE CLOCK ASSEMBLY (w/o Multi-information Display)Click here