NAVIGATION SYSTEM (for HDD) Microphone Circuit between Microphone and Navigation Receiver Assembly

DESCRIPTION

This circuit sends a microphone voice signal from the telephone microphone assembly to the navigation receiver assembly.

It also supplies power from the navigation receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT NAVIGATION RECEIVER ASSEMBLY

   
   
   1. 

      Text in Illustration

      *a	Component with harness connected (Navigation Receiver Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition E2-5 (MACC) - Body ground Ignition switch ACC 4 to 6 V

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition E2-14 (SGND) - Body ground Always Below 1 Ω E2-13 (MIN-) - Body ground Always Below 1 Ω

   
   

   NG

   REPLACE NAVIGATION RECEIVER ASSEMBLY Click here

   OK

2. CHECK HARNESS AND CONNECTOR

   
   

   1. Disconnect the E2 navigation receiver assembly connector.

   2. Disconnect the Q15 telephone microphone assembly connector.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition E2-3 (SNS2) - Q15-4 (SNS2) Always Below 1 Ω E2-5 (MACC) - Q15-1 (MACC) Always Below 1 Ω E2-4 (MIN+) - Q15-3 (MIC+) Always Below 1 Ω E2-13 (MIN-) - Q15-5 (MIC-) Always Below 1 Ω E2-3 (SNS2) - Body ground Always 10 kΩ or higher E2-5 (MACC) - Body ground Always 10 kΩ or higher E2-4 (MIN+) - Body ground Always 10 kΩ or higher E2-13 (MIN-) - Body ground Always 10 kΩ or higher E2-14 (SGND) - Body ground Always 10 kΩ or higher

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR

   OK

3. INSPECT TELEPHONE MICROPHONE ASSEMBLY

   
   
   1. 

      Text in Illustration

      *a	Component with harness connected (Telephone Microphone Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition Q15-4 (SNS2) - Q15-5 (MIC-) Always Below 1 Ω

   
   

   NG

   REPLACE TELEPHONE MICROPHONE ASSEMBLY Click here

   OK

4. INSPECT TELEPHONE MICROPHONE ASSEMBLY

   
   

   1. Reconnect the E2 navigation receiver assembly connector.

   2. 

      Text in Illustration

      *a	Component with harness connected (Telephone Microphone Assembly)

      Reconnect the Q15 telephone microphone assembly connector.

   3. Turn the ignition switch to ACC.

   4. Connect an oscilloscope to terminals 3 (MIC+) and 5 (MIC-) of the Q15 telephone microphone assembly connector.

   5. Check the waveform of the telephone microphone assembly using the oscilloscope.

      Result
      Result Proceed to A waveform synchronized with the voice input to the telephone microphone assembly is output A A waveform synchronized with the voice input to the telephone microphone assembly is not output B

   
   

   NG

   REPLACE TELEPHONE MICROPHONE ASSEMBLY Click here

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here