Click here

REAR VIEW MONITOR SYSTEM (w/ Navigation System) HOW TO PROCEED WITH TROUBLESHOOTING

Click here
Click here
Tip:

Use the following procedure to troubleshoot the rear view monitor system.


  1. Click here

    VEHICLE BROUGHT TO WORKSHOP


    • NEXT
  2. Click here

    CUSTOMER PROBLEM ANALYSIS


    • NEXT
  3. Click here

    INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the ignition switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


      • NEXT
  4. Click here

    PROBLEM SYMPTOM CONFIRMATION

    Result
    Result Proceed to
    Symptom does not occur A
    Symptom occurs B

    • B
    • Go to step 6
    • A
  5. Click here

    SYMPTOM SIMULATION


    • NEXT
  6. Click here

    CHECK FOR NAVIGATION SYSTEM DTC


    1. Check for Navigation System DTCs.

      Tip:
      Result
      Result Proceed to
      DTCs are not output A

      DTCs are output

      (w/ Navigation System (for DVD))

      		 B

      DTCs are output

      (w/ Navigation System (for HDD))

      		 C

      • B
      • GO TO DIAGNOSTIC TROUBLE CODE CHART FOR NAVIGATION SYSTEM (for DVD) (See pageClick here)
      • C
      • GO TO DIAGNOSTIC TROUBLE CODE CHART FOR NAVIGATION SYSTEM (for HDD) (See pageClick here)
      • A
  7. Click here

    CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM


    1. Refer to Navigation System.

      Tip:
      Result
      Result Proceed to
      Symptom does not appear A
      Symptom appears B

      • B
      • GO TO NAVIGATION SYSTEM (FOLLOW TO PERFORM TROUBLESHOOTING)
      • A
  8. Click here

    PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table (Click here).

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      • B
      • Go to step 10
      • A
  9. Click here

    PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM


    1. Refer to Terminals of ECU (Click here).


      • NEXT
  10. Click here

    ADJUST, REPAIR OR REPLACE


    • NEXT
  11. Click here

    CONFIRMATION TEST


    • NEXT
    • END