RADIO ANTENNA CORD INSTALLATION


  1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY

    Tech Tips

    The double-sided tape and tape are not available as supply parts. If these tapes still have enough adhesion to secure the roof headlining and antenna cord, reuse the tapes. If the roof headlining has been replaced with a new one, or if the tape and/or the double-sided tape is no longer sticky, apply new tape following the procedures below.


    1. Apply new double-sided tape.

      A017FHOE01

      1. Remove the double-sided tape from the roof headlining assembly.

      2. Peel off the appropriate amount of new double-sided tape. Be careful not to touch the adhesive surface.

      3. Apply the double-sided tape to the roof headlining while aligning the tape with the markings on the roof headlining assembly.

      4. Peel off the backing sheet from the double-sided tape.

    2. Install the antenna cord to the roof headlining assembly from the front of the vehicle.

      A017CEVE01

    3. Put the strips of the tape back to the positions shown in the illustration in order to secure the antenna cord to the roof headlining assembly.

      Tech Tips

      For the right front corner of the roof headlining assembly, align the marking tape on the antenna cord with the protrusion of the roof headlining, and wrap tape around the antenna cord and roof headlining assembly once or twice to securely hold them.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. INSTALL ANTENNA CORD SUB-ASSEMBLY


    1. Engage the 9 clamps and install the antenna cord sub-assembly.

      A017G31E01

  4. INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)


    1. A017DU2

      Install the navigation antenna with the 2 screws.

    2. A017BOT

      Engage the 3 clamps and install the navigation antenna assembly.

  5. INSTALL CENTER HEATER TO REGISTER SUB DUCT


    1. A017DU7

      Install the center heater to register sub duct with the 2 screws <E>.

  6. INSTALL DEFROSTER NOZZLE ASSEMBLY


    1. A017F5D

      Install the defroster nozzle assembly with the 3 screws <E> and clip.

  7. INSTALL SIDE NO. 2 DEFROSTER NOZZLE DUCT


    1. A017B1G

      Install the side No. 2 defroster nozzle duct with the screw <E>.

  8. INSTALL SIDE NO. 1 DEFROSTER NOZZLE DUCT


    1. A017DON

      Install the side No. 1 defroster nozzle duct with the screw <E>.

  9. INSTALL NO. 4 HEATER TO REGISTER DUCT


    1. A017DAC

      Install the No. 4 heater to register duct with the 3 screws <E>.

  10. INSTALL NO. 1 HEATER TO REGISTER DUCT


    1. A017D2S

      Install the No. 1 heater to register duct with the 3 screws <E>.

  11. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY

    Click here