AUDIO AND VISUAL SYSTEM Radio Receiver Power Source Circuit

DESCRIPTION

This circuit provides power to the radio receiver.

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   INSPECT RADIO RECEIVER

   
   
   1. 

      Disconnect the radio receiver connector.

   2. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition E6-7 (GND) - Body ground Always Below 1 Ω

   3. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition E6-4 (B) - E6-7 (GND) Always 11 to 14 V E6-3 (ACC) - E6-7 (GND) Ignition switch on (ACC) 11 to 14 V

   
   
   • OKClick here
   • NGClick here
2. Click here

   PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLEClick here

3. Click here

   REPAIR OR REPLACE HARNESS OR CONNECTOR