Click here

METER / GAUGE SYSTEM, Diagnostic DTC:U0129

Click here
Click here
DTC Code DTC Name
U0129 Lost Communication with Skid Control ECU
Click here

DESCRIPTION

The combination meter assembly communicates with the skid control ECU via the CAN communication system (CAN No. 1 Bus).

DTC No. DTC Detection Condition Trouble Area
U0129

When either of following conditions detected:


  1. 15 seconds have elapsed since engine started and IG voltage 10.5 V or more

  2. No communication with skid control ECU continues for 3 seconds or more (No communication with ECM and skid control ECU continues for 60 seconds or more)

  • Skid control ECU

  • CAN communication system
Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    CONFIRM DTC OUTPUT


    1. Connect the intelligent tester to the DLC3.

    2. Ignition switch on (IG).

    3. Turn the tester on.

    4. Clear the stored DTCs by selecting the following menu items on the tester: Body Electrical / Trouble Codes.

    5. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

    6. Stop the vehicle.

    7. Check for DTCs (Click here).

      Result
      Result Proceed to
      DTC is output. A
      DTC is not output. B
      Tip:

      If CAN communication system DTC U0129 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0129 first.


  2. Click here

    USE SIMULATION METHOD TO CHECKClick here

  3. Click here

    GO TO CAN COMMUNICATION SYSTEMClick here