STEERING PAD SWITCH INSTALLATION

INSTALL STEERING PAD SWITCH ASSEMBLY
1. Engage the 2 pins and install the steering pad switch assembly.
2. Install the screw.
  
  Torque:
  
  2.4 N*m { 24 kgf*cm, 21 in.*lbf }
3. Engage the 2 pins and install the steering pad switch assembly.
4. Install the screw.
  
  Torque:
  
  2.4 N*m { 24 kgf*cm, 21 in.*lbf }
5. Connect the pad switch connector to the spiral cable.
INSTALL STEERING PAD
1. Check that the ignition switch is off.
2. Check that the battery negative (-) terminal is disconnected.
  
  CAUTION:
  
  Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.
3. Support the steering pad with one hand as shown in the illustration.
4. Connect the 2 airbag connectors to the steering pad.
  
  Note
  
  When handling the airbag connector, take care not to damage the airbag wire harness.
5. Connect the horn connector to the steering pad.
6. Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
7. Using a "TORX" socket wrench (T30), tighten the 2 "TORX" screws.
  
  Torque:
  
  8.8 N*m { 90 kgf*cm, 78 in.*lbf }
INSTALL LOWER NO. 3 STEERING WHEEL COVER
1. Install the lower No. 3 steering wheel cover with the claw.
INSTALL LOWER NO. 2 STEERING WHEEL COVER
1. Install the lower No. 2 steering wheel cover with the claw.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSPECT STEERING PAD
1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
  - Cuts, minute cracks or marked discoloration on the steering pad top surface or grooves.
2. Make sure that the horn sounds.
  
  Tech Tips
  
  If the horn does not sound, inspect the horn system Click here.
INSPECT SRS WARNING LIGHT

Click here