DOOR CONTROL TRANSMITTER (w/o Smart Entry and Start System) REMOVAL


  1. REMOVE TRANSMITTER BATTERY (for RHD)

    Note

    Special caution should be taken for handling each component as they are precision electronic components.


    1. A017F4Z

      Using a screwdriver with its tip wrapped with protective tape, pry open the transmitter housing cover.

      Note

      Do not forcibly pry the cover.

    2. A017DXE

      Remove the battery (lithium battery).

      Note


      • Do not push the terminals with your finger.

      • Do not forcibly pry up the battery. The terminals may become damaged.

      • Do not touch the battery with wet hands. Water may cause rust.

      • Do not touch or move any components inside the transmitter. It may cease to work.

  2. REMOVE TRANSMITTER HOUSING COVER (for LHD)


    1. A017EVO

      Using a screwdriver with its tip wrapped with protective tape, pry open the transmitter housing cover.

      Note

      Do not forcibly pry the cover.

  3. REMOVE DOOR CONTROL TRANSMITTER MODULE (for LHD)


    1. A017CZ1

      Using a screwdriver with its tip wrapped with protective tape, remove the door control transmitter module from the transmitter housing case.

      Note

      Handle each part with care as they are delicate electrical parts.

  4. REMOVE TRANSMITTER BATTERY (for LHD)


    1. A017EWL

      Twist the coin in the direction of the arrow mark in the illustration, and remove the transmitter battery's cover.

    2. A017EK1

      Remove the battery (lithium battery: CR2016).

      Note


      • Do not push the terminals with your finger.

      • Do not forcibly pry up the battery. The terminals may become damaged.

      • Do not touch the battery with wet hands. Water may cause rust.

      • Do not touch or move any components inside the transmitter. It may cease to work.