WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Entry and Start System) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Enter the following menus: Body / MAIN BODY or Entry&Start / Data List.

    4. Read the Data List according to the display on the tester.

      MAIN BODY (Main body ECU):
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Wireless Control Wireless door lock control function / ON or OFF

      ON: Operating

      OFF: Not operating

      		 -
      Hazard Answer Back Hazard answer-back of wireless / ON or OFF

      ON: Operating

      OFF: Not operating

      		 -

      Open Door Warning*

      		Open door warning / ON or OFF

      ON: Operating

      OFF: Not operating

      		 -

      Unlock 2 Operation*

      		Unlock 2 Operation of wireless unlock / ON or OFF

      ON: All doors unlock when UNLOCK switch pressed twice

      OFF: All doors unlock when UNLOCK switch pressed once

      		 -
      Auto Lock Time Automatic lock time / 120 s, 60 s or 30 s

      120 s: 120 seconds

      60 s: 60 seconds

      30 s: 30 seconds

      		 -

      Wireless Buzzer Resp*

      		Wireless door lock buzzer response / ON or OFF

      ON: Operating

      OFF: Not operating

      		 -

      Tech Tips

      *: for RHD

      Entry&Start (Certification ECU (Smart Key ECU Assembly)):
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note

      Panic Alarm Function*

      		Panic function / ON or OFF

      ON: Operating

      OFF: Not operating

      		 -

      Tech Tips

      *: for RHD

  2. ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing the Active Test early in troubleshooting is one way to save diagnostic time. The Data List can be displayed during the Active Test.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Enter the following menus: Body / MAIN BODY or Entry&Start / Active Test.

    4. Perform the Active Test according to the display on the tester.

      MAIN BODY (Main body ECU):
      Tester Display Test Part Control Range Diagnostic Note
      Hazard Turns the turn signal flasher relay ON/OFF Observe headlight and rear combination light for correct operation

      Vehicle Horn*

      		Turns the vehicle horns ON/OFF -
      Illuminated Entry System Interior light and ignition key cylinder light (Interior light switch is in DOOR position and all doors are closed) ON/OFF -
      Trunk and Back-Door Open Turns the back door opener motor ON/OFF Observe back door
      Entry&Start (Certification ECU (Smart Key ECU Assembly)):
      Tester Display Test Part Control Range Diagnostic Note

      Wireless Buzzer Operation*

      		Turns the wireless door lock buzzer ON/OFF -

      Tech Tips

      *: for RHD