Click here

WASHER LEVEL WARNING SWITCH INSTALLATION

Click here
Click here
  1. Click here

    INSTALL LEVEL WARNING SWITCH ASSEMBLY


    1. A017EC4E01

      Install the level warning switch assembly.

    2. Connect the connector.

  2. Click here

    FILL WASHER JAR WITH WASHER FLUID


    1. A017GAN

      Connect the washer hose to the front washer motor and pump assembly and fill the washer jar with washer fluid.

  3. Click here

    INSTALL FRONT FENDER LINER RH


    1. A017CFW

      Install the front fender liner RH with the 5 clips and 8 screws.

    2. Install the bolt.

    3. A017CZV

      Install 3 new grommets.

    4. Using a 4 mm hexagon wrench, install the 2 screws.

    5. A017FP4E01

      Install the screw and 2 pin hold clips.

      Table 1. Text in Illustration
      *1 Correct
      *2 Incorrect
      Note:

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

  4. Click here

    INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY RH

    Tip:

    Use the same procedure as for the LH side.

  5. Click here

    INSTALL FRONT BUMPER ASSEMBLY


    1. Connect each fog light connector, and then install the front bumper assembly.

    2. A017E0P

      Engage the 5 claws.

      Tip:

      Use the same procedure for the RH side and LH side.

    3. Install the 3 clips and 8 screws.

    4. A017D06E01

      Install the screw and 2 pin hold clips.

      Table 2. Text in Illustration
      *1 Correct
      *2 Incorrect
      Note:

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

      Tip:

      Use the same procedure for the RH side and LH side.

  6. Click here

    INSTALL RADIATOR GRILLE SUB-ASSEMBLY


    1. A017F4G

      Engage the 2 guides and 8 claws, and install the radiator grille sub-assembly.

    2. Install the 6 clips.

  7. Click here

    INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 11 clips.

  8. Click here

    ADJUST FOG LIGHT AIMING (w/ Fog Light)

    (Click here)