WASHER LEVEL WARNING SWITCH INSPECTION


  1. INSPECT LEVEL WARNING SWITCH ASSEMBLY


    1. A017EPXE01

      Remove the washer jar.

    2. Disconnect the level warning switch connector.

      Tech Tips

      The check should be performed with the level warning switch assembly installed to the washer jar.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      1 (SLR1) - 2 (E) Washer jar is full 10 kΩ or higher
      1 (SLR1) - 2 (E) Washer jar is empty Below 1 Ω

      If the result is not as specified, replace the level warning switch assembly.