TURN SIGNAL FLASHER ASSEMBLY INSTALLATION


  1. INSTALL TURN SIGNAL FLASHER ASSEMBLY (for LHD)


    1. Connect the connector.

    2. A017G2M

      Engage the claw and install the turn signal flasher assembly.

  2. INSTALL TURN SIGNAL FLASHER ASSEMBLY (for RHD)


    1. A017BZS

      Engage the claw and install the turn signal flasher assembly.

    2. Connect the connector.

  3. INSTALL POWER STEERING ECU ASSEMBLY (for LHD)


    1. A017FRG

      Install the power steering ECU assembly with the 3 nuts.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }
    2. A017C2SE01

      Check that the connector lever is at the fully unlocked position before installation.

      Note

      If the lever has been lifted out of the fully unlocked position, it may cause a faulty connection.

    3. A017FWJE01

      Connect the 4 connectors to the power steering ECU assembly.

    4. Lightly pull on the connector and check that the connector does not disconnect.

  4. CONNECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (for LHD)


    1. A017C4M

      Connect the instrument panel junction block assembly with the 3 nuts.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

  5. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY

    Click here