TURN SIGNAL FLASHER ASSEMBLY INSPECTION


  1. INSPECT TURN SIGNAL FLASHER ASSEMBLY


    1. A017FHYE05

      Disconnect the D11 turn signal flasher assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      D11-1 (IG) - Body ground Ignition switch off Below 1 V
      Ignition switch on (IG) 11 to 14 V
      D11-4 (B) - Body ground Always 11 to 14 V

      If the result is not as specified, there is a malfunction on the wire harness side.

    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      D11-5 (EL) - Body ground Turn signal switch OFF 11 kΩ or higher
      Turn signal switch in LH position Below 1 Ω
      D11-6 (ER) - Body ground Turn signal switch OFF 11 kΩ or higher
      Turn signal switch in RH position Below 1 Ω
      D11-7 (E) - Body ground Always Below 1 Ω
      D11-8 (HAZ) - Body ground Hazard warning switch OFF 11 kΩ or higher
      Hazard warning switch ON Below 1 Ω

      If the result is not as specified, there is a malfunction on the wire harness side.

    4. A017C6DE05

      Reconnect the D11 turn signal flasher assembly connector.

    5. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      D11-2 (LR) - Body ground Hazard warning switch OFF Below 1 V
      Hazard warning switch ON 11 to 14 V (60 to 120 times per minute)
      Turn signal switch OFF Below 1 V
      Ignition switch on (IG) and turn signal switch in RH position 11 to 14 V (60 to 120 times per minute)
      D11-3 (LL) - Body ground Hazard warning switch OFF Below 1 V
      Hazard warning switch ON 11 to 14 V (60 to 120 times per minute)
      Turn signal switch OFF Below 1 V
      Ignition switch on (IG) and turn signal switch in LH position 11 to 14 V (60 to 120 times per minute)

      If the result is not as specified, replace the turn signal flasher assembly.