FRONT WIPER MOTOR INSPECTION


  1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)


    1. A017DJAE10

      Check the LO operation.


      1. Connect the battery's positive (+) lead to terminal 5 (+1) and the negative (-) lead to terminal 4 (E), and check that the motor operates at low speed (LO).

        OK
        Motor operates at low speed (LO).

    2. Check the HI operation.


      1. Connect the battery's positive (+) lead to terminal 3 (+2) and the negative (-) lead to terminal 4 (E), and check that the motor operates at high speed (HI).

        OK
        Motor operates at high speed (HI).

    3. Check the automatic stop operation.


      1. Put the matchmark on the windshield wiper motor assembly.

      2. Connect the battery's positive (+) lead to terminal 5 (+1) and the negative (-) lead to terminal 4 (E). With the motor rotating at low speed (LO), disconnect terminal 5 (+1) to stop the wiper motor operation at any position other than the matchmark.

      3. Using SST, connect terminals 1 (+S) and 5 (+1). Then connect the battery's positive (+) lead to terminal 2 (B) and the negative (-) lead to terminal 4 (E) to restart the motor operation at low speed (LO).

        SST
        09843-18040
      4. A017CDEE03

        Check that the motor stops automatically at the matchmark.

        OK
        Motor stops automatically at the matchmark.

        If the result is not as specified, replace the motor assembly.

  2. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)

    A017DJAE11

    1. Check the LO operation.


      1. Connect the battery's positive (+) lead to terminal 1 (+1) and the negative (-) lead to terminal 5 (E), and check that the motor operates at low speed (LO).

        OK
        Motor operates at low speed (LO).

    2. Check the HI operation.


      1. Connect the battery's positive (+) lead to terminal 4 (+2) and the negative (-) lead to terminal 5 (E), and check that the motor operates at high speed (HI).

        OK
        Motor operates at high speed (HI).

    3. Check the automatic stop operation.


      1. Put the matchmark on the windshield wiper motor assembly.

      2. Connect the battery's positive (+) lead to terminal 1 (+1) and the negative (-) lead to terminal 5 (E). With the motor rotating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the matchmark.

      3. Using SST, connect terminals 3 (+S) and 1 (+1). Then connect the battery's positive (+) lead to terminal 2 (B) and the negative (-) lead to terminal 5 (E) to restart the motor operation at low speed (LO).

        SST
        09843-18040
      4. A017E4XE02

        Check that the motor stops automatically at the matchmark.

        OK
        Motor stops automatically at the matchmark.

        If the result is not as specified, replace the motor assembly.