Click here

FOG LIGHT ASSEMBLY INSTALLATION

Click here
Click here
  1. Click here

    INSTALL FOG LIGHT ASSEMBLY


    1. A017FJP

      Engage the 3 claws and pin to install the fog light assembly.

  2. Click here

    INSTALL FOG LIGHT COVER


    1. A017E7L

      Engage the 7 claws and guide to install the fog light cover LH.

    2. A017DWG

      Engage the claw to install the outside moulding retainer.

  3. Click here

    INSTALL FRONT BUMPER ASSEMBLY


    1. Connect each fog light connector, and then install the front bumper assembly.

    2. A017E0P

      Engage the 5 claws.

      Tip:

      Use the same procedure for the RH side and LH side.

    3. Install the 3 clips and 8 screws.

    4. A017D06E01

      Install the screw and 2 pin hold clips.

      Table 1. Text in Illustration
      *1 Correct
      *2 Incorrect
      Note:

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

      Tip:

      Use the same procedure for the RH side and LH side.

  4. Click here

    INSTALL RADIATOR GRILLE


    1. A017F4G

      Engage the 2 guides and 8 claws, and install the radiator grille sub-assembly.

    2. Install the 6 clips.

  5. Click here

    INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 11 clips.

  6. Click here

    ADJUST FOG LIGHT AIMING

    (Click here)