HEADLIGHT ASSEMBLY REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A017EZQ

      Remove the 11 clips and cool air intake duct seal.

  2. REMOVE RADIATOR GRILLE


    1. A017GBWE01

      Put protective tape around the radiator grille.

    2. A017DWF

      Remove the 2 bolts and 4 clips.

    3. A017G18

      Disengage the 6 claws and 4 guides, and remove the radiator grille.

  3. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)


    1. A017DF7E01

      Put protective tape around the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    2. A017B8ZE01

      Remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A017EXI

      Remove the 7 screws and clip.

    5. A017B44

      Disengage the 4 claws and disconnect the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. Remove the front bumper assembly.

  4. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)


    1. A017DF7E01

      Put protective tape around the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    2. A017B8ZE01

      Remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A017EXI

      Remove the 7 screws and clip.

    5. A017B44

      Disengage the 4 claws and disconnect the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. Disconnect each fog light connector, and then remove the front bumper assembly.

  5. REMOVE REAR FENDER SPLASH SHIELD SUB-ASSEMBLY


    1. A017F95

      Disengage the 3 clips and 3 guides, and remove the rear fender splash shield sub-assembly.

  6. REMOVE HEADLIGHT ASSEMBLY


    1. A017G1T

      Remove the bolt and 2 screws.

    2. Disengage the claw and disconnect the headlight assembly.

    3. A017CUM

      Disengage the clamp.

    4. Disconnect the connectors and remove the headlight assembly.