ENGINE IMMOBILISER SYSTEM (w/o Smart Entry and Start System), Diagnostic DTC:B2799

DTC Code DTC Name
B2799 Engine Immobiliser System Malfunction

DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detects errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.

DTC No. DTC Detection Condition Trouble Area
B2799

One of following conditions is met:


  • Error in communication between ECM and transponder key ECU

  • Error in communication lines

  • Communication ID is different during communication with transponder key ECU

  • Wire harness or connector

  • ECM

  • Transponder key ECU assembly

WIRING DIAGRAM

A017CB9E14

INSPECTION PROCEDURE

Note


  • If the transponder key ECU is replaced, register the key and ECU communication ID.

  • If the ECM is replaced, register the ECU communication ID.

PROCEDURE


  1. CHECK DTC OUTPUT


    1. Delete the DTCs Click here.

    2. Recheck for DTCs.

      OK
      B2799 output does not recur.

    NG

    RE-REGISTER ECU COMMUNICATION ID Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  2. RE-REGISTER ECU COMMUNICATION ID


    1. Re-register the ECU communication ID.


    NEXT

  3. CHECK DTC OUTPUT


    1. Delete the DTCs Click here.

    2. Recheck for DTCs.

      OK
      B2799 output does not recur.

    NG

    CHECK CONNECTION OF CONNECTOR Click here

    OK

    END (PROBLEM WITH ECU COMMUNICATION ID IS DEFECTIVE)

  4. CHECK CONNECTION OF CONNECTOR


    1. Turn the ignition switch off.

    2. Check that the connectors are properly connected to the ECM and the transponder key ECU.

      OK
      Connectors are properly connected.

    NG

    CONNECT CONNECTORS PROPERLY

    OK

  5. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)


    1. Disconnect the transponder key ECU and ECM connectors.

      A017DDIE02

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      D37-12 (EFII) - D32-15 (IMO) Always Below 1 Ω
      D37-13 (EFIO) - D32-16 (IMI) Always Below 1 Ω
      D37-12 (EFII) - Body ground Always 10 kΩ or higher
      D37-13 (EFIO) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  6. REPLACE ECM


    1. Replace the ECM Click here.


    NEXT

  7. REGISTER ECU COMMUNICATION ID


    1. Register the ECU communication ID.


    NEXT

  8. CHECK DTC OUTPUT


    1. Delete the DTCs Click here.

    2. Recheck for DTCs.

      OK
      B2799 output does not recur.

    NG

    REPLACE TRANSPONDER KEY ECU ASSEMBLY

    OK

    END (ECM IS DEFECTIVE)