ENGINE HOOD COURTESY SWITCH INSTALLATION

INSTALL HOOD LOCK ASSEMBLY

1. 

   Apply MP grease to the sliding areas of the lock.

2. 

   Connect the hood lock control cable.

3. 

   Install the hood lock assembly with the 3 bolts.

   8.0 N*m

   82 kgf*cm

   71 in.*lbf

4. 

   Install the hood lock nut cap.

5. 

   Connect the connector.

INSPECT HOOD SUB-ASSEMBLY

1. 

   Check that the clearance measurements of areas A through D are within each standard range.

   Standard clearance
   Area Measurement Area Measurement A 6.2 to 10.2 mm (0.244 to 0.402 in.) C 2.5 to 5.5 mm (0.098 to 0.217 in.) B 5.9 to 9.9 mm (0.232 to 0.390 in.) D -1.5 to 1.5 mm (-0.059 to 0.059 in.)

ADJUST HOOD SUB-ASSEMBLY

1. Horizontally and vertically adjust the hood.

   
   
   1. 

      Loosen the 4 hinge bolts of the hood.

   2. Adjust the clearance between the hood and front fender by moving the hood.

   3. Tighten the 4 hinge bolts after the adjustment.

      13 N*m

      133 kgf*cm

      10 ft.*lbf

2. Adjust the height of the front end of the hood using the cushion rubber.

   
   
   1. 

      Adjust the cushion rubbers so that the heights of the hood and fender are aligned.

      Tip:

      Raise or lower the front end of the hood by turning the cushion rubber.

3. Adjust the hood lock.

   
   
   1. 

      Remove the hood lock nut cap.

   2. 

      Loosen the 3 bolts.

   3. Tighten the bolts after the adjustment.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

   4. 

      Install the hood lock nut cap.

   5. Check that the striker can engage with the hood lock smoothly.

INSTALL RADIATOR GRILLE

1. 

   Engage the 4 guides and 6 claws, and install the radiator grille.

2. 

   Install the 4 clips and 2 bolts.

INSTALL COOL AIR INTAKE DUCT SEAL

1. 

   Install the cool air intake duct seal with the 11 clips.