ENGINE HOOD COURTESY SWITCH INSTALLATION


  1. INSTALL HOOD LOCK ASSEMBLY


    1. A017EIN

      Apply MP grease to the sliding areas of the lock.

    2. A017BQ6

      Connect the hood lock control cable.

    3. A017CI6

      Install the hood lock assembly with the 3 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    4. A017FVJ

      Install the hood lock nut cap.

    5. A017EVU

      Connect the connector.

  2. INSPECT HOOD SUB-ASSEMBLY


    1. Check that the clearance measurements of areas A through D are within each standard range.

      A017F7IE01
      Standard clearance
      Area Measurement Area Measurement
      A 6.2 to 10.2 mm (0.244 to 0.402 in.) C 2.5 to 5.5 mm (0.098 to 0.217 in.)
      B 5.9 to 9.9 mm (0.232 to 0.390 in.) D -1.5 to 1.5 mm (-0.059 to 0.059 in.)

  3. ADJUST HOOD SUB-ASSEMBLY


    1. Horizontally and vertically adjust the hood.


      1. A017BMZ

        Loosen the 4 hinge bolts of the hood.

      2. Adjust the clearance between the hood and front fender by moving the hood.

      3. Tighten the 4 hinge bolts after the adjustment.

        Torque:
        13 N*m  { 133 kgf*cm, 10 ft.*lbf }

    2. Adjust the height of the front end of the hood using the cushion rubber.


      1. A017FJE

        Adjust the cushion rubbers so that the heights of the hood and fender are aligned.

        Tech Tips

        Raise or lower the front end of the hood by turning the cushion rubber.

    3. Adjust the hood lock.


      1. A017FVJ

        Remove the hood lock nut cap.

      2. A017BLJ

        Loosen the 3 bolts.

      3. Tighten the bolts after the adjustment.

        Torque:
        8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
      4. A017FVJ

        Install the hood lock nut cap.

      5. Check that the striker can engage with the hood lock smoothly.

  4. INSTALL RADIATOR GRILLE


    1. A017CEC

      Engage the 4 guides and 6 claws, and install the radiator grille.

    2. A017DWF

      Install the 4 clips and 2 bolts.

  5. INSTALL COOL AIR INTAKE DUCT SEAL


    1. A017EZQ

      Install the cool air intake duct seal with the 11 clips.